Workshop Manual

0312 1642 - 0138
9/22
© 11/2004
4
4 Technical data
4.1 Test and adjustment data
2011
02 00 Drive system
01 70 toggle lever / toggle lever block
01 72 toggle lever bore for toggle lever axle
(outlet)
18
±0.27
mm
01 73 toggle lever bore for toggle lever axle
(inlet)
18
±0.27
mm
01 74 diameter of the toggle lever axle 17.97
±0.01
mm
01 93 Roughness of the sealing surface 15 - 18 Rz
01 98 Length of the cylinder head screw
Standard 150.000
+0.8
-0.8
mm
ID
No.
Name Additional information Value Unit
02 02 Main bearing pin
02 03 Diameter of the main bearing pin Standard 69.970 - 69.990 mm
02 04 Undermeasure graduation for main
bearing pin
1. Stage 0.25 mm
2. Stage 0.50 mm
02 05 Limit value for undermeasure
graduation of the main bearing pin
69.47 mm
02 06 Unroundness of the main bearing pin Wear limit 0.008 mm
02 07 Surface hardness of the main bearing
pin
Standard 58
+4
HRC
02 10 Fit bearing pin
02 11 Width of fit bearing pin 35
+0.04
mm
02 12 Undermeasure graduation for fit bearing
pin
1. Stage 0.4 mm
02 13 Limit value for undermeasure
graduation of the fit bearing pin (width)
35.44 mm
ID
No.
Name Additional information Value Unit