Workshop Manual

Crankcase
W 03-11-01
0312 1581 - 0138
7/10
© 11/2004
6
2011
z Measure the installation depth of the camshaft
bearing with the depth measuring appliance from the
crankcase joint to the camshaft bearing.
Note
- Correct the installation depth of the camshaft
bearing if necessary.
- Installation depth, see schematic diagram.
z Remove the assembly tool.
© 39315 0
Install outer camshaft bearing
z Mount outer camshaft bearing.
Note
- Note position of joint (1), see schematic
diagram.
- Check that the oil bores (2) in the camshaft
bearing and the crankcase match up.
- In the camshaft bearing on the flywheel side,
the bores (3) for the setting bolts must match
up with the camshaft lock.
© 39316 0
2
3
1
z Insert counterbearing (1) in inner camshaft
bearing.
z Insert spindle and fit washer and nut.
z Insert extraction bus in outer camshaft
bearing.
Note
- Do not change the installation position of the
camshaft bearing.
- Make sure that the counterbearing is evenly
in contact with the crankcase.
© 39307 0
1