Workshop Manual

0312 1581 - 0138

2/10

Crankcase

W 03-11-01

2011

z Press in all tappets.

z Pull out camshaft (1) carefully to the flywheel side.

Check the camshaft bearing.

Prepare internal measuring device

z Mount probe bolt for the appropriate measuring

range in the internal measuring device.

z Mount meter with approx. 1 mm pre-tension in the

internal measuring device.

z Set micrometer gauge to 54 mm.

z Balance the internal measuring device between the

test surfaces of the micrometer gauge and set the

meter to the reversal point of the pointer to "0".

Note

Schematic representation for measuring the

camshaft bearing at the points "a" and "b" in

the levels "1" and "2".