Workshop Manual

0312 1578 - 0138

8/18

Crankcase

W 03-08-03

2011

z Set setting screw (1) for full load stop to

dimension "X".

z Tighten lock nut (2).

05 04

05004

z Screw in setting screw (1) for shutoff stop so that the

lock nut is flush with the end of the bolt (arrows).

z Tighten lock nut.

05007

z Set setting screw (1) for minimum speed to

dimension "X".

Note

The setting dimension ”X” only serves as a

basic setting. A test stand run is necessary for

the performance and speed setting.

z Tighten lock nut (2).

05 05

05005