Workshop Manual

Drive system

W 02-09-03

0312 1570 - 0138

7/8

2011

z Oil cylinder running surface, piston, piston rings and

lifting bearing journal lightly.

z Clamp piston rings with piston ring tensioning

band (1).

Note

Do not turn the piston rings any more.

z Set lifting bearing journal in the lower dead point.

Note

- Note the cylinder assignment of the piston.

- Note the identification (1) of the installation

position on the piston base, the symbol

flywheel/crankshaft must face the flywheel.

- The piston ring tensioning band must lie flat

on the crankcase.

z Push the piston into the cylinder with the con rod.

z Press the con rod carefully against the lifting journal.

Note

Do not jam the con rod with the crankshaft.