Workshop Manual

Drive system
W 02-04-01
0312 1569 - 0138
7/10
© 11/2004
6
2011
Install all con rod bearing covers
z Pull the con rods carefully onto the lifting bearing
journal.
© 39348 0
Note
- Note the assignment of the con rod bearing
cover.
- The numeric identification on the
con rod bearing cover and the con rod must
be identical and be opposite each other in
assembly (1).
- The numeric identification is facing the
operating side.
© 39349 0
1
z Tighten nuts.
Note
- Con rod bolts and nuts can be used a max. 5
times in case of provability, otherwise always
change them.
- Use a twelve-edge box wrench.
© 39350 0
02020