Workshop Manual

0312 1567 - 0138

4/8

Drive system

W 02-03-01

2011

Note

Schematic representation for measuring the

con rod bearing bore at the points ”a” and ”b”

in the levels ”1” and ”2”.

z Measure con rod bearing bore with internal

measuring device.

Insert internal measuring device in the con rod

bearing bore.

z Balance the internal measuring device respectively

at the given measuring points and read the

measured value at the reversal point of the pointer.

Note

If the measured values deviate slightly,

additional measurements must be made with

new bearing shells.

02 55

Check con rod bearing shell internal diameter

z Unscrew nuts and remove con rod bearing cover.

z Insert con rod bearing shell in the con rod.

Note

- Note the assignment of the bearing shells.

- The twist protection (1) must engage in the

groove (2).