Workshop Manual

Drive system

W 02-03-01

0312 1567 - 0138

3/8

2011

Check the con rod bearing bore

z Mount con rod bearing cover on con rod.

Note

The numeric identification (1) on the con rod

and the con rod bearing cover must be

identical and be opposite each other in

assembly.

z Tighten nuts.

Note

Use a twelve-edge box wrench.

02020

Prepare internal measuring device

z Mount probe bolt for the appropriate measuring

range in the internal measuring device.

z Mount meter with approx. 1 mm pre-tension in the

internal measuring device.

z Set micrometer gauge to 58.50 mm.

z Balance the internal measuring device between the

test surfaces of the micrometer gauge and set the

meter to the reversal point of the pointer to ”0”.