Workshop Manual

0312 1567 - 0138
2/8
© 11/2004
6
Drive system
W 02-03-01
2011
z Measure piston bolt bush with internal measuring
device.
Insert the internal measuring device in the piston bolt
bush.
z Balance the internal measuring device respectively
at the given measuring points and read off the
measured value at the reversal point of the pointer.
Note
- Piston bolt bush pressed in.
- Measuring points, see schematic diagram.
z Remove and install piston bolt bush
Î Job card W 02-03-03.
© 34770 1
02 43
Check diameter of the piston bolt
z Measure piston bolt with micrometer gauge.
© 35908 1
02 61
Determine piston bolt clearance
Note
The piston bolt clearance is given by the
difference between the piston bolt bush
internal diameter "A" and the diameter of the
piston bolt "B".
E
xamp
l
e:
Dimension "A" 26.035 mm
— Dimension ”B” 26.000 mm
=
Piston bolt
clearance
0.035 mm
02 45