Workshop Manual

1/4

2011

Drive system

W 02-02-02

W 02-02-02 Renew crankshaft sealing ring (flywheel side)

Tools

- Commercial tools

Assembly lever

- Special tools

142 860 - Assembly tool

References

- W 12-06-01

Remove crankshaft sealing ring

z Remove flywheel

Î Job card W 12-06-01.

z Loosen the crankshaft sealing ring (arrow) in its seat

with a pin.

z Carefully drill a hole (at least 3 mm Ø) diameter in the

crankshaft sealing ring.

Note

- Coat the drill thickly with grease so that no

drill chips fall into the crankcase.

- Do not damage the rear cover and

crankshaft.