Workshop Manual

0312 1564 - 0138
4/4
© 11/2004
6
Drive system
W 02-01-07
2011
Check axial clearance
z Place startup ring halves on fit bearing cover
(arrows).
z Measure width with micrometer gauge.
z Note the measured value (dimension ”B”).
Note
The dimension "B" is required for determining
the axial clearance.
© 35827 1
z Determine axial clearance
Axial clearance = dimension ”A” – dimension ”B”
z Use the appropriate startup ring halves.
02 34
02 35 02 36
Visual inspection
z Visually inspect the running surfaces (arrows) of the
shaft sealing rings.
z Install crankshaft
Î Job card W 02-04-01.
© 39182 0
Example:
Dimension "A" 35.00 mm
- Dimension ”B” 34.80 mm
= Axial clearance 0.20 mm