Workshop Manual

1/4
6
2011
Drive system
W 02-01-07
W 02-01-07 Check crankcase
Tools
- Commercial tools
Magnetic measuring stand
Micrometer gauge
Internal measuring device
Prisms
Hardness tester
- Special tools
100 400 - Meter
Note
If the crankshaft is worn it is possible to
have the crankshaft repaired in our
Service Centers.
References
- W 02-04-01
Note
The rework stages are marked on the
outer contour of the crankshaft face on the
flywheel side.
H = ground main bearing pin
P = ground con rod bearing pin
Check bearing pin hardness
z Remove crankshaft
Î Job card W 02-04-01.
z Place the crankshaft on prisms.
© 39176 0
z Check baring pin with hardness tester.
Note
The measured values must be converted
according to the table of the measuring
instrument.
© 39177 0
02 07
© 11/2004 0312 1564 - 0138