Workshop Manual

Cylinder head
W 01-02-02
0312 1556 - 0138
3/4
© 11/2004
6
2011
z Tighten (1) screws alternately.
Note
- Make sure that the stop rods are not under
stress due to valve overlap when tightening
the bolts.
- Align toggle lever to the stop rods/valves.
z Check and set valve clearance
Î Job card W 01-01-01.
© 39143 0
1
01002
z Clean the sealing surface on the cylinder head cover
and cylinder head.
z Fit gasket.
Note
Note installation position, the gate (arrow)
must face the front cover.
© 39138 0
z Mount cylinder head cover and tighten screws
alternately.
© 39139 0
01004