Operation Manual
Table Of Contents
6
© 2002
Service and Maintenance 6.1 Lubrication System
6.1.3 Changing Oil Filter
● With fitted torsion lock:
Loosen screws and slide clamps down-
wards.
● Undo the filter cartridge with commercial tool
and spin off.
● Catch any dripping oil.
● Clean any dirt from the filter carrier rim.
● Lightly oil the rubber gasket of the new oil
filter cartridge.
● Screw in the new cartridge finger tight
against the gasket.
● Check that the cartridge is correctly seated
against the gasket and tighten with a final
half-turn.
● If a torsion lock is fitted:
Slide clamps up into position and tighten
screws.
● Check oil level (see 6.1.2).
● Check oil pressure (see 3.3.1).
● Check cartridge seal.
Beware of burns from hot oil.
!
© 25 882 0
© 25 881 0
© 25 880 0