Product Info

EnoPuck
®
CO2 / CO2 NOISE / CO2 WALL
Product manual Page 20 of 32
© DEUTA Controls GmbH Paffrather Str. 140, 51465 Bergisch Gladbach Tel.:[phone]
23.11.2022 Hauptstraße 76, 32479 Hille Tel: [phone] - 0
Technical data might change [e-mail]; www.deuta-controls.dnet Fax:[phone] - 28
6 Functional description in detail
6.1 Basic device description
The EnoPuck
®
CO2 / EnoPuck
®
CO2 NOISE / EnoPuck
®
CO2 WALL is basically a
multi sensor with integrated LEDs. Each sensor can be configured to be switched off,
or to send the measured value in a fixed timed interval.
6.2 Send Teach-In telegrams
To be able to use standardized EEP (EnOcean Equipment Profiles), the EnoPuck
®
CO2 / EnoPuck
®
CO2 NOISE / EnoPuck
®
CO2 WALL can send all data in a
sequence, using different ID’s and different EEP’s.
To connect to any building automation system, a so called Teach-In telegram will be
send by the device using the Service button.
Figure 4: Location of Service buttons
The button is located on the side, approx. 3 cm to the right of the socket for the plug-in
power supply, and can be operated with a paper clip.
6.2.1 CO2 Teach-In (A5-09-04)
If the button is pressed 1x briefly within 2 seconds, a learning telegram for the EEP
A5-09-04 is sent after the 2 seconds have elapsed.