Product Info

EnoPuck
®
CO2 / CO2 NOISE / CO2 WALL
Product manual Page 14 of 32
© DEUTA Controls GmbH Paffrather Str. 140, 51465 Bergisch Gladbach Tel.:[phone]
23.11.2022 Hauptstraße 76, 32479 Hille Tel: [phone] - 0
Technical data might change [e-mail]; www.deuta-controls.dnet Fax:[phone] - 28
4.4 Factory settings
The basic configuration of an EnoPuck
®
CO2 / EnoPuck
®
CO2 NOISE / EnoPuck
®
CO2 WALL is actually as follows:
EnoPuck® Color Level R/red [%] Level green/G [%] Level blue/B [%]
Green 0 4 0
Yellow 10 7 0
Orange 6 1 0
EnoPuck® Sensor Enabled Transmit interval
CO2 / Temp. / RH
PIR (see Note 1)
Brightness
Sound Pressure Level
Note 1): Auto-Off / Energy saving
At the same time, the EnoPuck’s PIR is activated. If nobody has been detected by the
PIR for more than 20 minutes, LEDs will turn off.
4.5 External product interface
4.5.1 EnoPuck
®
CO2 / EnoPuck
®
CO2 NOISE
The products have the following external interfaces:
• Passive infrared sensor for people detection (front)
• Service button to send teach in / learn telegram and to start re-calibration
•
Connection socket for external power supply