Operation Manual

Electrical system
9
98 Caravan - 14-09 - EN
Depending on the model, the flap for the 240 V connection is identified with the
symbol " ".
Connecting the power cable:
 Open external flap at the caravan.
 Depending on the model, fold up the cover.
 Plug in the plug.
 Plug the plug into the electrical socket of the power supply unit at the caravan
site.
 Switch on the main cut-off switch at the caravan.
 Check whether the fault-current protection switch in the caravan functions by
pressing the test button and switch it back on.
Disconnecting the supply line:
 Switch off the main cut-off switch at the caravan.
 Unplug the plug at the electrical socket of the power supply unit at the caravan
site.
 Remove the plug at the caravan.
X If a CEE 17 angled connector with socket mounted on rear (Fig. 89,1) is used,
use only a rubberised and sealed IP 44 plug with earth contact (Fig. 89,2). Do
not use a plug without earth contact (Fig. 89,3). Danger of electrocution!
X In cases of faults or if the supply is not available or is faulty after you have car-
ried out the procedure above, inform the caravan site operator.
Z Depending on the model, unlock the plug before pulling it out.