Operation Manual

Maintenance
13
162 Caravan - 14-09 - EN
Check whether the condensation drain holes (Fig. 156,1) are free and if necessary
clean at regular intervals.
13.7 Replacing bulbs and fluorescent tubes
13.7.1 Halogen spotlight
Changing bulbs:  Loosen the fixing screws (Fig. 157,1).
 Carefully remove the lamp chalice (Fig. 157,2) from the holder.
 Remove halogen bulb.
 Put in a new halogen bulb.
 Reassemble the lamp in the reverse order.
X Bulbs and light fittings can be extremely hot. Therefore, allow lights to cool
down before changing bulbs.
X Before changing bulbs, switch off the power supply at the safety cut-out in
the 240 V fuse box.
X Store bulbs in a safe place inaccessible to children.
X Do not use any bulb that has been dropped or which shows scratches in its
glass. The bulb might burst.
X Lights can get very hot. WHen the light is switched on, a safety distance of
30 cm to combustible material has to be maintained. Fire hazard!
Z New bulbs should not be touched with the fingers. Use a cloth when inserting
the new bulb.
Z Only use bulbs of the same type and with the correct wattage.
Z If LEDs in the lights are defective, contact an authorised dealer or a service
centre.
Fig. 157 Halogen spotlight (movable)
1
2
2