Operation Manual

Electrical system
9
96 Caravan - 12-11 - EN
9.9 Fuses
9.9.1 12 V fuses
The appliances connected to the 12 V power supply in the living area are fused indi-
vidually. The fuses are accessible on the power pack and on the transformer/recti-
fier.
An intact 12 V fuse can be detected by the unbroken fuse element (Fig. 97,1). If the
fuse element is broken (Fig. 97,2), change the fuse.
Before changing fuses, take the function, value and colour of the relevant fuses
from the following specifications. When changing fuses, only use flat fuses with the
values shown below.
X Only replace defective fuses when the cause of the defect is known and has
been remedied.
X Only replace defective fuses when the power supply is switched off.
X Never bridge or repair fuses.
Fig. 97 12 V fuse
1 Unbroken fuse element
2 Broken fuse element
Function Value/colour
Fuses at the living area
battery (Power Pack SE)
Cable from the living area battery to the power supply
unit
40 A red
Cable from the living area battery to the power supply
unit
2 A grey
Fuse on power pack
(transformer H)
Main fuse 15 A blue
Fuses on power pack
(switched-mode power
supply type I)
Circuit 1 15 A blue
Circuit 2 15 A blue
Circuit 3 15 A blue
Circuit 4 15 A blue
Fuses on power pack
(switched-mode power
supply type II)
Circuit 1 15 A blue
Circuit 2 5 A light brown
Circuit 3 15 A blue
Circuit 4 15 A blue