Operation Manual

Appliances
10
118 Caravan - 12-11 - EN
Gas operation The boiler is operated exclusively with gas.
Switching on:
 Remove cap from waste gas vent.
 Open the regulator tap on the gas bottle and the gas isolator tap "Boiler".
 Set the rotary switch (Fig. 125,3) to " " (Fig. 125,5). The green "Operation" indi-
cator lamp illuminates the knob (Fig. 125,1).
 Adjust the knob (Fig. 125,1) to the required water temperature.
The red indicator lamp (Fig. 125,2) illuminates when there is a fault (see Chapter
15).
Switching off:
 Set the rotary switch (Fig. 125,3) on the operating unit (Fig. 125) to " "
(Fig. 125,4).
 Close the gas isolator tap "Boiler" and the regulator tap on the gas bottle.
 Place cap on waste gas vent.
The red indicator lamp (Fig. 125,2) illuminates when there is a fault (see Chapter
15).
230 V electrical operation The boiler is operated exclusively with electricity.
Switching on:
 Connect the vehicle to the external 230 V power supply and switch on the 230
V automatic circuit breaker.
 Set the flip switch (Fig. 126,1) to on. The indicator lamp on the switch is illumi-
nated. The water in the boiler is heated up to 65 °C.
Fig. 125 Operating unit for Truma boiler
(gas operation)
1 Temperature control knob
2 Red indicator lamp "Fault"
3 Rotary switch
4 Off
5 On
230V~
Boiler
ruma
1
2
3
4
5
70
60
50
40
30
Z 230 V electrical operation is only possible when the vehicle is connected to the
230 V power supply.
Fig. 126 Flip switch for Truma boiler (230
V electrical operation)
230V~
Boiler EL
ruma
1