Operation Manual

Appliances

112 Caravan - 12-11 - EN

10.2.8 Electrical floor warming unit

The regulator for the electrical floor warming unit is installed in the bench seat or

in the wardrobe, depending on the model.

Operating levels The electrical floor warming unit has four operating levels:

z 0 "Off"

z 20 V "low heating level"

z 22 V "medium heating level"

z 24 V "high heating level"

Switching on:

 Connect the vehicle to the 230 V power supply (see Section 9.8.1).

 Turn the control knob (Fig. 118,2) to the desired heating level.

Switching off:

 Turn the control knob (Fig. 118,2) to the setting "0".

After switching off, the floor remains warm for a while, due to residual heat.

If the regulator is overloaded, the overload protection is actuated. The pin

(Fig. 118,1) will trip.

Switching on overload

protection:

 Press in the pin (Fig. 118,1) at the overload protection when the regulator has

cooled down.

X On models with electrical floor warming unit, never drill holes in the floor or

screw in any screws. Caution with sharp-edged or pointed objects. There is

danger of a power cut or a short circuit due to damage to a heater wire.

Z Do not cover the regulator. Danger of overheating!

Z The electrical floor warming unit only operates if the vehicle is connected to the

230 V power supply.

Z The output of the electrical floor warming unit alone is not sufficient to heat the

living area.

Fig. 118 Regulator for electrical floor war-

ming unit