Operation Manual

Appliances
10
107Caravan - 12-11 - EN
10.2.5 Alde hot-water heater
The hot-water heater has been fitted below in the wardrobe.
Operating unit The operating unit is divided into two sections:
z Display (touch screen)
z Control buttons
Control buttons The control buttons have the following functions:
Display The display (Fig. 115,1) is designed as a touch screen. Touching the symbols calls
up the relevant function.
Z Never run the hot-water heater without heating fluid. Observe the specifica-
tions in Chapter 13.
Z Never drill holes in the floor. This might damage the hot-water pipes.
Z Do not use the space above and behind the heater as a storage compartment.
Z The circulating pump must always be turned on when the hot-water heater is
in operation.
Z We recommend bleeding the heating system after the initial heater operation
to checking the glycol content. Observe the specifications in Chapter 13.
Z When the heater is turned on, it starts with the last settings used.
Z For further information, see the separate manufacturer's instruction manual
and observe the maintenance instructions found in Chapter 13.
Z For further information about the use of the boiler see Section "Boiler".
Fig. 115 Operating unit for hot-water
heater
1 Display (touch screen)
2 "Menu" button
3 On/Off button
Z If no button is pressed, the operating unit automatically switches to the home
position after two minutes.
Z Changes to the settings are saved automatically after 10 seconds.
No. in
Fig. 115
Button Function
2 MENU Open adjustment menu
3
Activate heating