Operation Manual

Appliances
10
104 Caravan - 12-11 - EN
Changing the battery on the
automatic ignition:
 Ensure that the heater is switched off.
 Remove the heater cover (Fig. 107,2). To do so pull the cover upwards and for-
wards, press the retaining springs (Fig. 107,1) at the side upwards and swing the
cover to the front.
 Place the cover (Fig. 108,1) on the side so that the connecting cables for the hot-
air fan as well as for the ignition indicator lamp do not have to be disconnected.
 Slide the cover of the battery compartment at the automatic ignition
(Fig. 108,2) upwards.
 Remove the old battery from the battery compartment of the automatic igni-
tion.
 Insert a new battery (Fig. 108,3) of the same type into the battery compartment
of the automatic ignition, observing the correct polarity (+/-). Use only tempe-
rature-resistant (+70 °C) and leak-proof Mignon batteries.
 Slide the cover of the battery compartment at the automatic ignition down-
wards.
 Press the locking lever to the right until the latch engages audibly.
 Mount the heater cover. To do so put the cover (Fig. 109,1) onto the lower
retainer latches (Fig. 109,2).
 Insert the operating rod from below into the grip recess and let the cover latch
in at the top.
Fig. 107 Removing the heater cover Fig. 108 Heating opened
Fig. 109 Heater cover, retainer latches