Operation Manual

Maintenance
13
162 Caravan - 12-10 - EN
13.8 Replacing bulbs and fluorescent tubes
13.8.1 Ceiling lamp (cover with screws)
Changing bulbs:
 Undo the screws (Fig. 170,1) and carefully remove the glass cover (Fig. 170,2).
 Remove bulb.
 Put in a new bulb.
 Fasten the glass cover again.
X Bulbs and light fittings can be extremely hot. Therefore, allow lights to cool
down before changing bulbs.
X Before changing bulbs, switch off the power supply at the safety cut-out in
the 230 V fuse box.
X Store bulbs in a safe place inaccessible to children.
X Do not use any bulb that has been dropped or which shows scratches in its
glass. The bulb might burst.
X Lights can get very hot. WHen the light is switched on, a safety distance of
30 cm to combustible material has to be maintained. Fire hazard!
Z New bulbs should not be touched with the fingers. Use a cloth when inserting
the new bulb.
Z Only use bulbs of the same type and with the correct wattage.
Z If LEDs in the lights are defective, contact an authorised dealer or a service
centre.
Fig. 170 Ceiling lamp
1 2 1