Operation Manual

72 Caravan - 09-09 - DET-0030-09EN
Living
7
Mechanical operation The rear bed is raised or lowered with a hand crank.
Lifting the bed:
 Insert the hand crank (Fig. 75,3) in the crank socket (Fig. 75,2) in the bed
frame (Fig. 75,1) and turn the hand crank until the bed is a little higher than
the desired position of the support brackets or at the end position.
 Bring the four support brackets (Fig. 76,2) to the desired height and insert
the safety tabs in the holes (Fig. 76,3) on the four support rails (Fig. 76,1).
 Turn the hand crank until the bed lies on the support brackets.
 Remove hand crank and store securely.
Lowering the bed:
 Insert the hand crank (Fig. 75,3) in the crank socket (Fig. 75,2) on the bed
frame (Fig. 75,1) and turn the hand crank until the bed has moved up a
little.
 Pull out the four support brackets (Fig. 76,2) from the holes (Fig. 76,3) on
the four support rails (Fig. 76,1) and re-insert them at the desired position.
 Turn the hand crank until the bed lies on the support brackets.
 Remove hand crank and store securely.
Electric operation The rear bed is raised or lowered with a rocker switch.
Lifting the bed:
 Press upper part of the rocker switch (Fig. 77,1) and keep it pressed until
the bed is located somewhat over the desired position or at the end posi-
tion.
 Bring the four support brackets (Fig. 78,2) to the desired height and insert
the safety tabs in the holes (Fig. 78,3) on the four support rails (Fig. 78,1).
 Press lower part of the rocker switch (Fig. 77,1) and keep it pressed until
the bed rests on the support brackets.
Fig. 75 Hand crank Fig. 76 Support bracket for the rear
bed
Fig. 77 Operating switch for the elec-
tronically adjustable rear bed
Fig. 78 Support bracket for the rear
bed