Operation Manual

151Caravan - 09-09 - DET-0030-09EN
Sanitary fittings
11
11.7.3 Vacuum toilet (Dometic)
The flushing of the toilet is fed directly from the water system of the vehicle.
Putting into operation:
 Turn on power supply. The yellow LED (Fig. 180,1) on the panel
(Fig. 179,1) turns on for ca. 1 minute. A vacuum is generated in the system.
 If the green LED (Fig. 180,3) on the panel lights up, lift the pedal
(Fig. 179,3) briefly, so that some water runs into the toilet bowl (Fig. 179,2)
and the stopper on the bottom is covered with water.
The vacuum toilet is ready for operation.
Flushing:
 Close the lid of the toilet.
 Press down the pedal (Fig. 179,3) for several seconds.
 Briefly lift the pedal, so that some water runs into the toilet bowl (Fig. 179,2)
and the stopper on the bottom is covered with water.
The red LED (Fig. 180,2) lights up if the cassette must be emptied or removed.
Removing the cassette:
 Remove the cassette and empty it as described in sections 11.7.4 and
11.7.5.
11.7.4 Removing the cassette
 Only flush the toilet if the toilet lid is closed.
Fig. 179 Vacuum toilet Fig. 180 Vacuum toilet panel
 Flushing only functions if the green LED is lit.
 The sewage tank (cassette) can only be taken out if the sliding trap is
closed.