Operation Manual

124 Caravan - 09-09 - DET-0030-09EN
Appliances
10
Filling the boiler with water:  Close drain cocks. Position the rocking levers (Fig. 145,1) horizontally.
 Switch on 12 V power supply on the panel.
 Set all the water taps to "Hot" and open them. The water pump is turned
on. The warm water pipes are filled with water.
 Keep the taps open until the water flowing out of the taps has no bubbles
in it. This is the only way to ensure that the boiler is full of water.
 Close all water taps.
Emptying the boiler:
 Switch off boiler.
 Open all water taps and set to the central position.
 Open drain cocks (Fig. 145). To do this, set the rocking levers (Fig. 145,1)
in a vertical position. The boiler is drained to the outside using the drain
cocks.
 Check whether the water has been drained completely from the boiler
(approx. 12.5 litres).
10.4.4 Reich boiler
The boiler is operated with 240 V. The boiler heats about 5 l of water. The
water temperature can be set on the temperature controller (Fig. 146,1) of the
boiler. The water in the boiler can be heated up to a maximum of 80 °C.
 Depending on the model, the vehicle is fitted with one or two drain cocks.
Fig. 145 Drain cocks
 Further information can be obtained in the manufacturer's instruction
manual.
Fig. 146 Reich boiler