Operation Manual

113Caravan - 09-09 - DET-0030-09EN
Appliances
10
10.2.5 Alde hot-water heater
The hot-water heater has been fitted below in the wardrobe.
Operating unit The operating unit is divided into two sections:
 Display (touch screen)
 Control buttons
Control buttons The control buttons have the following functions:
Display The display (Fig. 134,1) is designed as a touch screen. Touching the symbols
calls up the relevant function.
 See installation instructions of the separate instruction manual for the
Airmix comfort package.
 Never run hot-water heater without heating fluid. Observe notes in
chapter 13.
 Never drill holes in the floor. This might damage the hot-water pipes.
 Do not use the space above and behind the heater as a storage compart-
ment.
 The circulating pump must always be turned on when the hot-water heater
is in operation.
 We recommend to bleed the heating system after the initial heater opera-
tion and to check the glycol content. Observe notes in chapter 13.
 When the heater is turned on, it starts with the last settings used.
 For further information, see the separate manufacturer's instruction manual
and observe the maintenance instructions found in chapter 13.
 For further information about the use of the boiler see section "Boiler".
Fig. 134 Operating unit for hot-water
heater
1 Display (touch screen)
2 "Menu" button
3 On/Off button
 When no button is pressed, the operating unit automatically switches to
home position after two minutes.
 Changes to the settings are saved automatically after 10 seconds.
Pos. in
Fig. 134
Button Function
2 MENU Open adjustment menu
3
Activate heating