Operation Manual

14
7C
aravan - 09-08 - DET-0030-08EN
Sanitary fittings
1
1
To empty and ventilate the water system, proceed as follows. This will avoid
frost damage:
Position the vehicle horizontally.
Switch off the 12 V power supply on the panel (Power Pack SE).
Switch off the 240 V power supply on the 240 V automatic circuit breaker.
Open all drain cocks.
Take off the external water connection.
Open all water taps and set to the central position.
Hang the shower handset up in the shower position.
Empty the waste water tank. Take note of the environmental tips in this
chapter.
Empty Thetford cassette. Take note of the environmental tips in this
chapter.
Clean the water tank and then rinse it out thoroughly.
Let the water system dry for as long as possible.
After emptying, leave all water taps on in the central position.
Leave all drain cocks open.
11.6 Toilet compartment
Take note of the environmental tip in this chapter.
Do not transport any loads in the shower tray. The shower tray or other
items of equipment in the toilet compartment can be damaged.
For ventilation purposes during or after a shower, and for drying wet
clothing, close the toilet compartment door and open the window or the
toilet compartment skylight. This improves the air circulation.
Close the shower curtain completely when showering, so that no water is
able to enter the area between the wash room wall and the shower tray.
After taking a shower, rinse soap residue from the shower tray, otherwise
cracks can appear in the shower tray over time.
After using the shower, wipe it dry to prevent moisture from collecting.
Further information about cleaning the toilet compartment can be found in
the section 12.3.