Operation Manual

11
1C
aravan - 09-08 - DET-0030-08EN
Appliances
1
0
10.2.5 Alde hot-water heater
The hot-water heater has been fitted below in the wardrobe.
Operating unit The operating unit is divided into two sections:
Display (Fig. 130,1)
Control buttons
See installation instructions of the separate instruction manual for the
Airmix comfort package.
Never run hot-water heater without heating fluid. Observe notes in
chapter 13.
Never drill holes in the floor. This might damage the hot-water pipes.
Do not use the space above and behind the heater as a storage compart-
ment.
The circulating pump must always be turned on when the hot-water heater
is in operation.
We recommend to bleed the heating system after the initial heater opera-
tion and to check the glycol content. Observe notes in chapter 13.
For further information, see the separate instruction manual "Alde Com-
pact" and observe the maintenance instructions found in chapter 13.
For further information about the use of the boiler see section "Boiler".
Fig. 130 Operating unit for hot-water
heater
1 LCD display
2 "Back" button
3 "Activate/Increase" button
4 "Forward" button
5 "Switch off/Decrease" button
6 "System reset" button
7 Lower menu line
8 Information line
9 Status line
10 Upper menu line
When no button is pressed, the operating unit automatically switches to
home position after two minutes.