Operation Manual

9
2 Motorcaravan - 09-08 - DET-0033-07E
N
Living
7
7.12.4 Bunk bed (side)
Depending on the model, the side area is fitted with a bunk bed. The bunk bed
can also be used as a storage area.
Converting the storage area
to a bunk bed:
Open the storage flap and fold out the support leg (Fig. 100,2) under the
bed.
Pull the loop (Fig. 100,1) and tilt the bed (Fig. 100,3) downwards.
Take the mattress (Fig. 101,3) off the top bed and place it on the bottom
bed.
Access ladder Always use the access ladder provided as standard to reach the top bed.
Attaching:
Attach the access ladder with the rails to the holder (Fig. 101,4) on the
panel.
Safety net The safety net (Fig. 101,1) is stored as standard between the mattress and
slatted frame. Do not use the safety net until the persons are already in bed.
Setting up:
Fasten the retaining straps (Fig. 101,2) to the holders on the ceiling.
The maximum permitted bunk bed load is 100 kg.
Only use the bunk bed, if the safety net is set up.
Never allow small children to remain in the bunk bed without supervision.
But in particular with regard to small children less than 6 years of age,
users should ensure that they cannot fall out of the bunk bed.
Use separate children's beds or travel cots suitable for children.
Remove the mattress from the bottom bed and put it on the top bed before
converting the bunk bed into a storage compartment.
Fig. 100 Supports and unlocking device Fig. 101 Bunk bed (side)