Operation Manual

3
3M
otorcaravan - 09-08 - DET-0033-07EN
Before the journey
4
Moving the clamping
eyelets:
Turn the clamping eyelet (Fig. 2,1) half a turn in an anticlockwise direction.
Push the clamping eyelet into the clamping rail (Fig. 2,2) to the desired
position.
Give clamping eyelet one half turn in a clockwise direction. The clamping
eyelet sits tightly in the clamping rail again.
Check that the clamping eyelet is tight.
4.3.6 Double floor
4.3.7 Sliding drawer
Depending on the vehicle equipment, clamping rails with clamping eyelets
are mounted in the rear garage or in the rear storage space. Always secure
loads onto the clamping eyelets. Always use tightening straps or lashing
nets for securing the load, never rubber expanders.
When clamping loads, always check that the clamping eyelets are placed
tightly in the clamping rails. If the clamping eyelet is not anchored tightly in
the clamping rail, the load may slide or loosen during forcible movements
of the steering wheel or when braking.
Distribute the load evenly. Excessive spot loads can lead to damages of
the floor covering.
Fig. 2 Clamping eyelets rear garage
1 Clamping eyelet
2 Clamping rail
Observe the permissible axle loads and maximum permissible gross
weight when loading the double floor.
Distribute the load evenly. Excessive spot loads can lead to damages of
the floor covering.
Do not place loads weighing more than 40 kg into the sliding drawer.