Operation Manual

21
9M
otorcaravan - 09-08 - DET-0033-07EN
Maintenance
1
3
13.6.1 Ceiling lamp (cover with screws)
Changing bulbs: Undo the screws (Fig. 247,1) and carefully remove the glass cover
(Fig. 247,2).
Remove bulb.
Put in a new bulb.
Fasten the glass cover again.
13.6.2 Ceiling lamp
Changing bulbs: Use a suitable tool (e.g. a screwdriver) to carefully lever out the cover
(Fig. 248,2) at the notch (Fig. 248,1) and remove it.
Remove bulb.
Put in a new bulb.
Reassemble the lamp in the reverse order.
Do not use any bulb that has been dropped or which shows scratches in
its glass. The bulb might burst.
Lights can get very hot. When the light is switched on, there must always
be a safety distance of 30 cm between light and flammable objects. Fire
hazard!
A new bulb should not be touched with the fingers. Use a cloth when
installing the new bulb.
Only use bulbs of the same type and with the correct wattage.
If LEDs in lights are defect, contact an authorised dealer or service centre.
Fig. 247 Ceiling lamp
Fig. 248 Ceiling lamp