Operation Manual

19
7M
otorcaravan - 09-08 - DET-0033-07EN
Sanitary fittings
1
1
For models with an double floor: Remove the cap from the waste water
drain neck and open the drain cock.
Open all water taps and set to the central position.
Hang the shower handset up in the shower position.
Hold the water pump up until the water pipes are completely empty.
Check whether the water tank is completely empty.
Blow out the remaining water in the water pipes (max. 0.5 bar). To do this,
remove the pipe from the water pump and blow into the pipe.
Empty the waste water tank. Take note of the environmental tips in this
chapter.
Empty Thetford cassette. Take note of the environmental tips in this
chapter.
Clean the water tank and then rinse it out thoroughly.
Let the water system dry for as long as possible.
After emptying, leave all water taps on in the central position.
Leave all drain cocks open.
11.7 Toilet compartment
The flip switches for the toilet compartment lighting are installed in different
places in the toilet compartment depending on the model.
For example, the light switch (Fig. 222,1) of the toilet compartment is located
under the bathroom cabinet.
Do not transport any loads in the shower tray. The shower tray or other
items of equipment in the toilet compartment can be damaged.
For ventilation purposes during or after a shower, and for drying wet
clothing, close the toilet compartment door and open the window or the
toilet compartment skylight. This improves the air circulation.
Close the shower curtain completely when showering, so that no water is
able to enter the area between the wash room wall and the shower tray.
After taking a shower, rinse soap residue from the shower tray, otherwise
cracks can appear in the shower tray over time.
After using the shower, wipe it dry to prevent moisture from collecting.
Further information about cleaning the toilet compartment can be found in
the section 12.2.
Fig. 222 Light switch