Operation Manual

94 Motorcaravan - 09-08 - DET-0033-07E

Sanitary fittings

Emptying: Place key (Fig. 217,2) onto the square bolt (Fig. 217,1).

In order to open the waste water tap, turn the square bolt a quarter turn.

Completely empty waste water tank.

To close the waste water tap, turn the square bolt back as far as it will go.

11.4.3 Odour seal

In order to prevent odours occurring in the waste water system, the vehicle -

depending on the model - has been equipped with odour seals (Fig. 218,1).

The odour seals are installed in the waste water pipes.

Clean the odour seals every two years at the latest. To do so, unscrew and

remove the bottom cover (Fig. 218,2).

With all the Globeline models, the odour seals are only accessible via a hole

in the floor plate. This hole is sealed with a cover plate and made splashproof.

To remove the siphon base, unscrew the four securing bolts and take off the

cover plate. The position of the cover plate is shown in the following illustra-

tion.

For models without double floor, remove the siphon base if there is a risk

of frost. This protects the siphon from freezing up.

If the siphon base is removed and the vehicle is used: Place a suitable tank

under the siphon to collect the waste water (not applicable for models with

double floors).

For motorhomes that have had "winter comfort package" special equip-

ment installed in the factory, the waste water pipes are electrically heated.

When the temperature drops below 5 °C, the frost protection equipment

turns on automatically.

Fig. 218 Odour seal

Fig. 219 Cover plate positions

1 Cover plate for T 7013

2 Cover plate for T 7043

3 Cover plate for T 6813 and T 7073