Operation Manual

1
82 Motorcaravan - 09-08 - DET-0033-07E
N
Appliances
1
0
Manual operation
Switching on:
Open the regulator tap on the gas bottle and the gas isolator tap "Refriger-
ator".
Press the on/off switch/energy selector switch (Fig. 195,1) down for 2 sec-
onds in order to switch on the appliance. The operating mode selected
most recently is shown in the operating indicator (Fig. 195,4).
Select the energy type with the on/off switch/energy selector switch
(Fig. 195,1).
Set the refrigerating temperature on the switch for temperature setting
(Fig. 195,6). The indicator LEDs (Fig. 195,5) show the selected thermostat
position.
Switching off:
Press down the on/off switch/energy selector switch (Fig. 195,1) for 2 sec-
onds. All displays close.
Close the gas isolator tap "Refrigerator" and the regulator tap on the gas
bottle.
10.6.7 Operation (Thetford)
Operating modes The refrigerator has 2 operating modes:
Gas operation
Electrical operation (240 V AC or 12 V DC)
The operating mode is set with the button (Fig. 196,4) on the refrigerator
panel.
Refrigerating temperature
control
When turned on the refrigerator automatically selects the thermostat position
selected last. This position can be adjusted manually by using the button
(Fig. 196,1). The bars on the display (Fig. 196,3) indicate the selected thermo-
stat position. The refrigerating temperature for the three types of energy is set
with the button. It takes a few hours till the refrigerator reaches its normal oper-
ating temperature. When changing over the operating mode the thermostat
setting will be maintained. The refrigerating temperature is retained regardless
of the type of power being used.
Further information can be obtained from the separate instruction manual
"Refrigerator".
The refrigerator starts when it is switched on with the setting selected last.
The display lights up for about 10 seconds as soon as a button is pressed.
In the event of a malfunction, the display flashes in second clock pulses
and an error code is displayed (see section 15.6.2).
Select only one energy source.
Even when the 12 V power supply is switched off, a small electrical power
flows which puts an extra load on the living area battery. Always switch off
the refrigerator for a temporary lay-up.