Operation Manual
15
7M
otorcaravan - 09-08 - DET-0033-07EN
Appliances
1
0
Slide the sliding regulator forwards or backwards to the desired position.
The side on which the sliding regulator is located is closed.
Turn the knob tight in the clockwise direction.
10.3.2 Truma
To execute the individual switching commands, always point the remote con-
trol in the direction of the receiver.
Switching on:
Connect the vehicle to the 240 V power supply. The air conditioning unit is
ready to operate.
Switch on the remote control with the switch (Fig. 173,7). The green indi-
cator lamp (Fig. 172,1) indicates cooling mode.
Set the desired operating mode with the key (Fig. 173,8).
"FAN": Only ventilation without cooling.
"COMFORT": Cooling. The fan output and the room temperature can be
set separately. The green indicator lamp in the receiver indicates the
compressor is in operation and therefore cooling mode.
Set the desired fan output and room temperature with the keys (Fig. 173,3
and 4) if necessary. The arrow (Fig. 173,9) indicates the selected setting
mode.
If the temperature set on the remote control is reached, the green indicator
lamp goes out, the compressor is switched off and the circulation fan con-
tinues to run.
Switching off:
To switch off, press the key (Fig. 173,7) on the remote control again.
The air conditioning unit only runs if the vehicle is connected to a 240 V
power supply.
The external 240 V power supply must be protected by a fuse of at least
3 A. It is otherwise not possible to operate the air conditioning unit properly.
Fig. 172 Receiver Fig. 173 Remote control
An additional key switch (Fig. 172,2) is on the receiver, which can be used
to switch the air conditioning unit off or on without remote control. If the air
conditioning unit is switched on by means of this key switch, the operating
mode set last on the remote control is automatically selected.
Condensation accumulates on the vaporiser in cooling mode. To counter-
act any formation of germs, operate the air conditioning unit about 5 to
10 minutes in the "FAN" and "HIGH" positions to dry the vaporiser.