Operation Manual

7
1C
aravan - 02-08 - DET-0030-07EN
Living
7
Mechanical operation The rear bed is raised or lowered with a hand crank.
Lifting the bed:
Insert the hand crank (Fig. 74,3) in the crank socket (Fig. 74,2) in the bed
frame (Fig. 74,1) and turn the hand crank until the bed is a little higher than
the desired position of the support brackets or at the end position.
Bring the four support brackets (Fig. 75,2) to the desired height and insert
the safety tabs in the holes (Fig. 75,3) on the four support rails (Fig. 75,1).
Turn the hand crank until the bed lies on the support brackets.
Remove hand crank and store securely.
Lowering the bed:
Insert the hand crank (Fig. 74,3) in the crank socket (Fig. 74,2) on the bed
frame (Fig. 74,1) and turn the hand crank until the bed has moved up a
little.
Pull out the four support brackets (Fig. 75,2) from the holes (Fig. 75,3) on
the four support rails (Fig. 75,1) and re-insert them at the desired position.
Turn the hand crank until the bed lies on the support brackets.
Remove hand crank and store securely.
The bed can be adjusted to any height between both end positions.
The socket for inserting the hand crank is located on the rear bed frame.
If the rear bed is operated electrically, the rocker switch for raising and low-
ering the rear bed is located in the upper section of the right partition wall.
Fig. 74 Hand crank Fig. 75 Support bracket for the rear
bed