Operation Manual

3
5C
aravan - 02-08 - DET-0030-07EN
Before the journey
4
Lay the drive-on ramp on the ground (Fig. 7).
Insert the edge guard (Fig. 7,1) in both holders in the drive-on ramp
(Fig. 7,2).
To push in the drive-on ramp, carry out the steps in reverse order.
4.7 PVC-floor covering
4.8 Television
Holder in the TV cabinet The flat screen is attached to a console in the TV cabinet.
Storing the flat screen:
Rotate the flat screen to its initial position and lock it into place.
Insert the holder for the flat screen on the handle (Fig. 8,1) until the latch
(Fig. 8,2) locks into place.
Close TV cabinet.
Holder with jointed arm The flat screen is fastened to a jointed arm.
Shoes with pointed heels can leave permanent impressions in the PVC-
floor covering. Never wear shoes with pointed heels in the vehicle.
Rubber mats or long exposure to ketchup, carrot juice, ink, blood or lipstick
can discolour the PVC floor covering. If possible, remove stains from the
floor immediately.
Before commencing the journey, remove the television from the support
and store it securely.
Before commencing the journey, turn the flat screen and the screen
holder back to the basic position and slide them in until they lock into
place. Close the TV cabinet.
Before commencing the journey, ensure that the antenna is in park posi-
tion. Danger of accidents! Park position means: The antenna points
towards the back, is fully lowered and is locked in this position.
Further information on positioning the flat screen can be obtained from
chapter 7.
Fig. 8 Holder in the TV cabinet