Operation Manual

16
7C
aravan - 02-08 - DET-0030-07EN
Maintenance
1
3
Close bleeding valve.
Repeat this procedure at all bleeding valves.
Check to see if the hot-water heater warms up.
13.6 Replacing bulbs and fluorescent tubes
13.6.1 Ceiling lamp (cover with screws)
Changing bulbs: Undo the screws (Fig. 187,1) and carefully remove the glass cover
(Fig. 187,2).
Remove bulb.
Put in a new bulb.
Fasten the glass cover again.
Bulbs and light fittings can be extremely hot. Therefore, allow lights to
cool down before changing bulbs.
Shut off the power supply on the safety cut-out in the 240 V fuse box
before changing bulbs.
Store bulbs in a safe place inaccessible to children.
Do not use any bulb that has been dropped or which shows scratches in
its glass. The bulb might burst.
Lights can get very hot. When the light is switched on, there must always
be a safety distance of 30 cm between light and flammable objects. Fire
hazard!
A new bulb should not be touched with the fingers. Use a cloth when
installing the new bulb.
Only use bulbs of the same type and with the correct wattage.
Fig. 187 Ceiling lamp