Operation Manual

16
5C
aravan - 02-08 - DET-0030-07EN
Maintenance
1
3
When the pin (Fig. 184,2) is in the longitudinal hole at the marking with the
"+", the friction pads are still in good condition.
When the pin is at both centre markings, the friction pads are slightly worn.
When the pin is at the marking with the "–", the friction pads are worn and
must be replaced.
13.4 Braking system BPW/AL-KO chassis
Have maintenance work on the braking system carried out by a specialist
workshop.
Look up the following table for the inspection deadlines.
13.5 Alde hot-water heater
It is not possible to reset the friction pads.
Model First inspection Braking system Brake lining
BPW
chassis
– Every 2,000 or
3,000 km or every
12 months
Every 5,000 km or
every 12 months
AL-KO
chassis
After 1,500 km or
after 6 months
Every 10,000 or
15,000 km or every
12 months
Every 5,000 km or
every 12 months
Check the level of the heating fluid regularly on the compensator reservoir.
The compensator reservoir can be found in the wardrobe.
During or after the first operating hours of the hot-water heater, the filling
level may fall below the minimum mark. If this is the case, top up the
heating fluid.
Dethleffs recommends to bleed the heating system after the initial heater
operation and to check the glycol content.
Have heating fluid changed by Dethleffs dealer at intervals of approxi-
mately two years as corrosion-protection wears off after some time.
Top up heating system with a water-glycol mixture (60 : 40) only. This mix-
ture offers frost protection up to approx. -25 °C.
Further information can be obtained from the separate instruction manual
"Alde Compact" heater.