Operation Manual

12
1C
aravan - 02-08 - DET-0030-07EN
Appliances
1
0
10.4.2 Truma boiler
The boiler is gas operated. The electrical control of the boiler is provided with
power by the living area battery.
Switching on:
Remove cap from waste gas vent.
Open the regulator tap on the gas bottle and the gas isolator tap "Boiler".
Switch the 12 V power supply on.
Turn the rotary switch (Fig. 139,3) to " " (Fig. 139,5). The green "Opera-
tion" indicator lamp illuminates the knob (Fig. 139,1).
Adjust the knob (Fig. 139,1) to the required water temperature.
The red indicator lamp (Fig. 139,2) illuminates when there is a fault (see
chapter 15).
Switching off:
Turn the rotary switch (Fig. 139,3) to " " (Fig. 139,4).
Close the gas isolator tap "Boiler" and the regulator tap on the gas bottle.
Place cap on waste gas vent.
The red indicator lamp (Fig. 139,2) illuminates when there is a fault (see
chapter 15).
Filling the boiler with water:
Close the drain cock (Fig. 140,2). To do this, set the rocking lever in a hor-
izontal position.
Close the drain cock (Fig. 140,1). To do this turn the cap in a clockwise
direction.
Switch on 12 V power supply on the panel.
Remove cap from waste gas vent before using the Truma boiler.
Fig. 139 Operating unit for Truma boiler
1 Temperature control knob
2 Red indicator lamp "Fault"
3 Rotary switch
4Off
5On
Fig. 140 Drain cocks