Operation Manual

11
7C
aravan - 02-08 - DET-0030-07EN
Appliances
1
0
10.2.8 Electrical floor warming unit
The regulator for the electrical floor warming unit is installed in the bench seat
or in the wardrobe, depending on the model.
Operating levels The electrical floor warming unit has four operating levels:
0 "Off"
20 V "Low heating level"
22 V "Medium heating level"
24 V "High heating level"
Switching on:
Connect the vehicle to the 240 V power supply (see section 9.8.1).
Turn the control knob (Fig. 135,2) to the required heating level.
Switching off:
Turn control knob (Fig. 135,2) to "0" position.
After switching off, the floor remains warm for a while, due to residual heat.
If the regulator is overloaded, the overload protection is actuated. The pin
(Fig. 135,1) jumps out.
Switching on overload
protection:
Press the pin (Fig. 135,1) on the overload protection when the regulator is
cooled.
On models with electrical floor warming unit, never drill holes in the floor
or screw in any screws. Careful with sharp objects. There is danger of a
power cut or a short circuit due to damage to a heater wire.
Do not cover the regulator. Danger of overheating!
The electrical floor warming unit only operates if the vehicle is connected
to the 240 V power supply.
The output of the electrical floor warming unit alone is not sufficient to heat
the living area.
Fig. 135 Regulator for electrical floor
warming unit