Operation Manual

11
1C
aravan - 02-08 - DET-0030-07EN
Appliances
1
0
10.2.5 Alde hot-water heater
The hot-water heater has been fitted below in the wardrobe.
Operating unit The operating unit is divided into two sections:
Display (Fig. 130,1)
Control buttons
Control buttons The control buttons have the following functions:
See installation instructions of the separate instruction manual for the
Airmix comfort package.
Never run hot-water heater without heating fluid. Observe notes in
chapter 13.
Never drill holes in the floor. This might damage the hot-water pipes.
Do not use the space above and behind the heater as a storage compart-
ment.
The circulating pump must always be turned on when the hot-water heater
is in operation.
Dethleffs recommends to bleed the heating system after the initial heater
operation and to check the glycol content. Observe notes in chapter 13.
For further information, see the separate instruction manual "Alde Com-
pact" and observe the maintenance instructions found in chapter 13.
For further information about the use of the boiler see section "Boiler".
Fig. 130 Operating unit for hot-water
heater
1 LCD display
2 "Back" button
3 "Activate/Increase" button
4 "Forward" button
5 "Switch off/Decrease" button
6 "System reset" button
7 Lower menu line
8 Information line
9 Status line
10 Upper menu line
When no button is pressed, the operating unit automatically switches to
home position after two minutes.