Operation Manual

6
9C
aravan - 11-06 - DET-0030-05EN
Living
7
Raising: Press upper part of the rocker switch (Fig. 66,1) and keep it pressed until
the bed is located somewhat over the desired position or at the end posi-
tion.
Insert the four support brackets (Fig. 67,1) into the drilled holes at the
desired height (Fig. 67,3) on the four support beams (Fig. 67,2) and press
them all the way in.
Press lower part of the rocker switch (Fig. 66,1) and keep it pressed until
the bed rests on the support brackets.
Lowering:
Press upper part of the rocker switch (Fig. 66,1) and keep it pressed until
the bed has slightly moved upwards.
Pull out the four support brackets (Fig. 67,1) from the drilled holes
(Fig. 67,3) on the four support beams (Fig. 67,2) and re-insert them at the
desired position.
Press lower part of the rocker switch (Fig. 66,1) and keep it pressed until
the bed rests on the support brackets.
7.11.5 Folding bed
Only lower or raise the bed when the space between the bed and the
side wall is clear.
Only lower the bed if the lowering area in the rear garage is clear.
The bed can be adjusted to any height between both end positions.
The rocker switch for lifting and lowering the rear bed is located in the top
section of the intermediate wall on the right side.
Fig. 66 Operating switch for the elec-
tronically adjustable rear bed
Fig. 67 Support bracket for the rear
bed
The maximum permitted folding bed load is 50 kg.
Always use folding bed with the safety net in position.
An uncontrolled opening of the bed can lead to an accident.
Never allow small children to remain in the folding bed without supervi-
sion.
But in particular with regard to small children less than 6 years of age,
users should ensure that they cannot fall out of the folding bed.
Use separate children's beds or travel cots suitable for children.