Operation Manual

1
70 Caravan - 11-06 - DET-0030-05E
N
Wheels and tyres
1
4
Check regularly that the wheel nuts or wheel bolts are firmly seated. Re-
tighten the wheel nuts or wheel bolts of a changed wheel cross-wise
(Fig. 190) after 50 km (30 miles).
When using new or newly painted rims, re-tighten the wheel nuts or wheel
bolts once again after approx. 1,000 to 5,000 km (600 miles to
3,000 miles).
For lay-ups or long periods of inactivity, keep the tyres and tyre bearings
free from pressure points:
Jack up the vehicle so that the wheels do not bear any load, or move the
vehicle every 4 weeks in such a way that the position of the wheels is
changed.
14.2 Tyre selection
The tyre sizes approved for the vehicle are given in the vehicle documents or
can be got from the Dethleffs dealers. Each tyre must fit the vehicle on which
it will be driven. This applies to the external dimensions (diameter, width),
which are indicated with the standardised size designations. In addition, the
tyres must meet the requirements of the vehicle with regard to weight and
speed.
Weight refers to the maximum permissible axle load which can be distributed
on two tyres. The maximum load-carrying capacity of a tyre is indicated by its
load index (= LI, load index code).
The maximum permissible speed for a tyre (with full load-carrying capacity) is
indicated by the speed index (= SI). Together, load index and speed index
form the operating code of a tyre. This is an official component of the com-
plete, standardised dimensions description which appears on every tyre. The
information on the tyres must correspond to the specifications which appear in
the vehicle papers.
Fig. 190 Tighten the wheel nuts or
wheel bolts cross-wise
A wrong tyre can damage the tyres during the journey and even cause
it to burst.
If tyres that are not approved for the vehicle are used, then the type
approval for the vehicle and subsequently the insurance coverage can
lapse. Your Dethleffs dealer will be pleased to advise you.