Operation Manual

14
3C
aravan - 11-06 - DET-0030-05EN
Sanitary fittings
1
1
To empty and ventilate the water system, proceed as follows. This will avoid
frost damage:
Position the vehicle horizontally.
Switch off the 12 V power supply on the panel (Power Pack SE).
Switch off the 240 V power supply on the 240 V automatic circuit breaker.
Open all drain cocks.
Take off the external water connection.
Open all water taps and set to the central position.
Hang the shower handset up in the shower position.
Empty the waste water tank. Take note of the environmental tips in this
chapter.
Empty Thetford cassette. Take note of the environmental tips in this
chapter.
Clean the water tank and then rinse it out thoroughly.
Let the water system dry for as long as possible.
After emptying, leave all water taps on in the central position.
Leave all drain cocks open.
11.6 Toilet compartment
The flip switches for the toilet compartment lighting are installed in different
places in the toilet compartment depending on the model.
For example, the light switch (Fig. 158,1) of the toilet compartment is located
under the bathroom cabinet.
Take note of the environmental tip in this chapter.
Do not transport any loads in the shower tray. The shower tray or other
items of equipment in the toilet compartment can be damaged.
Fig. 158 Light switch
For ventilation purposes during or after a shower, and for drying wet
clothing, close the washroom door and open the washroom skylight. This
improves the air circulation.
Close the shower curtain completely when showering, so that no water is
able to enter the area between the wash room wall and the shower tray.