Operation Manual

11
5C
aravan - 11-06 - DET-0030-05EN
Appliances
1
0
Manual mode The ventilation, cooling and heater can be set separately in manual mode.
Switching on the ventilation:
Set the mains switch (Fig. 124,4) to "I".
Use the " " (Fig. 124,1), "+" (Fig. 124,2) and "–" (Fig. 124,5) buttons to set
the desired cooling fan speed.
Switching on the cooling:
Set the mains switch (Fig. 124,4) to "I".
Press the "MODE & SET" button (Fig. 124,6) until the cooling symbol
appears in the display (Fig. 124,3).
Use the "+" (Fig. 124,2) and "–" (Fig. 124,5) buttons to set the desired tem-
perature.
Use the " " (Fig. 124,1), "+" (Fig. 124,2) and "–" (Fig. 124,5) buttons to set
the desired cooling fan speed.
Switching on the heater:
Set the mains switch (Fig. 124,4) to "I".
Press the "MODE & SET" button (Fig. 124,6) until the heating symbol
appears in the display (Fig. 124,3).
Use the "+" (Fig. 124,2) and "–" (Fig. 124,5) buttons to set the desired tem-
perature.
Use the " " (Fig. 124,1), "+" (Fig. 124,2) and "–" (Fig. 124,5) buttons to set
the desired cooling fan speed.
Switching off:
Set the mains switch (Fig. 124,4) to "0".
10.4 Boiler
10.4.1 Models with waste gas vent on the right-hand side of the
vehicle
Never let gas escape unburned due to danger of explosion.
When filling the fuel tank of the towing vehicle, on ferries or in the
garage, never run the boiler in gas operation. Danger of explosion!
Switch on the boiler and empty it if the vehicle is not used.
Never use boiler when empty.
If the boiler is not being used, empty it if there is any risk of frost.
Only operate the boiler with the maximum temperature setting if you
require a large quantity of warm water. This protects the boiler against the
build-up of limescale.
Dethleffs recommends that water from the boiler is not used as drinking
water.
If the awning is put up and the boiler is running in gas operation, exhaust
gases from the boiler can escape into the awning area. Danger of suffo-
cation! Make sure the area is sufficiently ventilated.