Operation Manual

1
06 Caravan - 11-06 - DET-0030-05E
N
Appliances
1
0
The hot air flow can be adjusted as required with the operating lever
(Fig. 115,1) on the back of the circulation fan. Factory setting is the central
position.
In the central position the warm air is distributed evenly to each warm air
outlet. The operating lever (Fig. 116,1) for the adjustment flap is located under
the base flap in the wardrobe.
Setting the hot air
distribution:
Undo bottom locker wood screws.
Remove bottom locker cover.
Push the operating lever (Fig. 116,1) in the direction of the arrow until the
required position has been reached.
10.2.4 Alde hot-water heater
The hot-water heater has been fitted below in the wardrobe.
Operating unit The operating unit is divided into two sections:
Display (Fig. 117,1)
Control buttons
Fig. 115 Circulation fan Fig. 116 Circulation fan, adjustment flap
in central position
Further information can be obtained from the separate instruction manual
"Trumavent".
Never run hot-water heater without heating fluid. Observe notes in
chapter 13.
Never drill holes in the floor. This might damage the hot-water pipes.
Do not use the space above and behind the heater as a storage compart-
ment.
Dethleffs recommends to bleed the heating system after the initial heater
operation and to check the glycol content. Observe notes in chapter 13.
For further information, see the separate instruction manual "Alde Com-
pact" and observe the maintenance instructions found in chapter 13.
For further information about the use of the boiler see section "Boiler".