Instruction Manual

ManualsBrandsDetex ManualsSafetyCNV Trim

FUNCTION

01C(N)

FUNCTIONFUNCTION

03C(N) 02C(N)

Detex Corporation, 302 Detex Drive, New Braunfels, Texas 78130-3045

(830)629-2900 / 1-800-729-3839 / Fax (830)620-6711

E-MAIL: detex@detex.com INTERNET: www.detex.com

101285 May 29, 2007

INSTALLATION INSTRUCTIONS FOR 03C(N), 02C(N), 01C(N) PULLPLATE TRIM

DETEX INS-101285

Summary of content (6 pages)

PAGE 1
01285 May 29, 2007 Detex Corporation, 302 Detex Drive, New Braunfels, Texas 78130-3045 (830)629-2900 / 1-800-729-3839 / Fax (830)620-6711 E-MAIL: detex@detex.com INTERNET: www.detex.
PAGE 2
03, 02, 01 PULLPLATE Trim Tools Required Power Drill Pencil Hammer Safety Glasses Tape Measure Screw Driver Center Punch 03 Trim Preparation (No prep necessary for 02 & 01 Trims) Cut Cylinder Tailpiece 1-1/16" (Min) 1-1/8" (Max) Tailpiece (see table) Tailpiece Used Door Thickness 1-3/4" and 2" Thick Doors 2-1/4" Thick Doors 1 Rim Cylinder Preparation 3 2 Install Tailpiece Assembly Page 2 Install Trim Unit on Door (see next page)
PAGE 3
Wide Trim Door Preparation For Narrow Trim Refer to Pages 5 & 6. 1 2 Mark Centerhole for 03 Function Mark Backplate Holes (wide stile shown) FLOOR Punch Marked Holes Interior Door Face Note: All Holes Must Be Drilled Straight and Level 4 3 For 03 And 01 Functions, Drill Pilot Hole Thru Door.
PAGE 4
8 7 9 Once Hole is Marked Drill 3/8" (1/2" max) Thru Hole. 8-1/2" For 01 Trims Measure from the Device Centerlines Mark Bottom Hole For Thru Bolt (for 01 trims see step number 8) Installing the Trim Position Tailpiece Vertically when Installing Trim Plate Fasten The Top of Pull To The Trim Plate Using Screw Provided 10 11 Be sure to Engage Cam to Tailpiece on Backplate Cam Orientation Label Not Shown for Clarity PlaceTrim Unit onto Exterior Door Face.
PAGE 5
Narrow Trim Door Preparation For Wide Trim Refer to Pages 3 & 4. 2 1 For 03 and 01 Functions Mark Centerhole Mark Backplate Holes (narrow stile shown) FLOOR Punch Marked Holes Interior Door Face Note: All Holes Must Be Drilled Straight and Level 4 3 For 03 And 01 Functions, Drill Pilot Hole Thru Door.
PAGE 6
8 7 9 Once Hole is Marked Drill 3/8" Thru Hole. 8-1/2" For 01 Trims Measure from the Device Centerlines Mark Bottom Hole For Thru Bolt (for 01 trims see step number 8) Installing the Trim Fasten The Top of Pull To The Trim Plate Using Screw Provided Position Tailpiece Vertically when Installing Trim Plate 10 11 PlaceTrim Unit onto Exterior Door Face.